[−][src]Struct lpc55s6x_pac::usbhsd::ulpidebug::R
Value read from the register
Methods
impl R[src]
pub fn bits(&self) -> u32[src]
Value of the register as raw bits
pub fn phy_addr(&self) -> PHY_ADDRR[src]
Bits 0:7 - ULPI mode: Bits 7:0 are used as the address when doing a register access over the ULPI interface.
pub fn phy_wdata(&self) -> PHY_WDATAR[src]
Bits 8:15 - UTMI+ mode: Reserved.
pub fn phy_rdata(&self) -> PHY_RDATAR[src]
Bits 16:23 - UTMI+ mode: Bits 7:0 contains the value returned by the VStatus signal on Vendor Interface of UTMI+.
pub fn phy_rw(&self) -> PHY_RWR[src]
Bit 24 - UTMI+ mode: Reserved.
pub fn phy_access(&self) -> PHY_ACCESSR[src]
Bit 25 - Software writes this bit to one to start a read or write operation.
pub fn phy_mode(&self) -> PHY_MODER[src]
Bit 31 - This bit indicates if the interface between the controller is UTMI+ or ULPI.
Auto Trait Implementations
Blanket Implementations
impl<T> From<T> for T[src]
impl<T, U> TryFrom<U> for T where
U: Into<T>, [src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>[src]
impl<T, U> Into<U> for T where
U: From<T>, [src]
U: From<T>,
impl<T, U> TryInto<U> for T where
U: TryFrom<T>, [src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>[src]
impl<T> Borrow<T> for T where
T: ?Sized, [src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized, [src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T[src]
impl<T> Any for T where
T: 'static + ?Sized, [src]
T: 'static + ?Sized,
impl<T> Same<T> for T[src]
type Output = T
Should always be Self