[][src]Enum lpc55s6x_pac::rtc::ctrl::RTC_SUBSEC_ENAR

pub enum RTC_SUBSEC_ENAR {
    POWER_UP,
    POWERED_DOWN,
}
[]

Possible values of the field RTC_SUBSEC_ENA

Variants

POWER_UP
[]

The sub-second counter (if implemented) is disabled. This bit is cleared by a system-level POR or BOD reset as well as a by the RTC_ENA bit (bit 7 in this register). On modules not equipped with a sub-second counter, this bit will always read-back as a '0'.

POWERED_DOWN
[]

The 32 KHz sub-second counter is enabled (if implemented). Counting commences on the start of the first one-second interval after this bit is set. Note: This bit can only be set after the RTC_ENA bit (bit 7) is set by a previous write operation. Note: The RTC sub-second counter must be re-enabled whenever the chip exits deep power-down mode.

Methods

impl RTC_SUBSEC_ENAR[src][]

pub fn bit_is_clear(&self) -> bool[src][]

Returns true if the bit is clear (0)

pub fn bit_is_set(&self) -> bool[src][]

Returns true if the bit is set (1)

pub fn bit(&self) -> bool[src][]

Value of the field as raw bits

pub fn is_power_up(&self) -> bool[src][]

Checks if the value of the field is POWER_UP

pub fn is_powered_down(&self) -> bool[src][]

Checks if the value of the field is POWERED_DOWN

Trait Implementations

impl PartialEq<RTC_SUBSEC_ENAR> for RTC_SUBSEC_ENAR[src][+]

#[must_use]
fn ne(&self, other: &Rhs) -> bool
1.0.0[src][]

This method tests for !=.

impl Copy for RTC_SUBSEC_ENAR[src]

impl Debug for RTC_SUBSEC_ENAR[src][+]

impl Clone for RTC_SUBSEC_ENAR[src][+]

fn clone_from(&mut self, source: &Self)1.0.0[src][]

Performs copy-assignment from source. Read more

Auto Trait Implementations

impl Send for RTC_SUBSEC_ENAR

impl Sync for RTC_SUBSEC_ENAR

Blanket Implementations

impl<T> From<T> for T[src][+]

impl<T, U> TryFrom<U> for T where
    U: Into<T>, 
[src][+]

type Error = Infallible

The type returned in the event of a conversion error.

impl<T, U> Into<U> for T where
    U: From<T>, 
[src][+]

impl<T, U> TryInto<U> for T where
    U: TryFrom<T>, 
[src][+]

type Error = <U as TryFrom<T>>::Error

The type returned in the event of a conversion error.

impl<T> Borrow<T> for T where
    T: ?Sized
[src][+]

impl<T> BorrowMut<T> for T where
    T: ?Sized
[src][+]

impl<T> Any for T where
    T: 'static + ?Sized
[src][+]

impl<T> Same<T> for T[src]

type Output = T

Should always be Self