[−][src]Struct lpc55s6x_pac::casper::loader::W
Value to write to the register
Methods
impl W[src]
pub fn reset_value() -> W[src]
Reset value of the register
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self[src]
Writes raw bits to the register
pub fn count(&mut self) -> _COUNTW[src]
Bits 0:7 - Number of control pairs to load 0 relative (so 1 means load 1). write 1 means Does one op - does not iterate, write N means N control pairs to load
pub fn ctrlbpair(&mut self) -> _CTRLBPAIRW[src]
Bit 16 - Which bank-pair the offset CTRLOFF is within. This must be 0 if only 2-up. Does not matter which bank is used as this is loaded when not performing an operation.
pub fn ctrloff(&mut self) -> _CTRLOFFW[src]
Bits 18:28 - DWord Offset of CTRL pair to load next.
Auto Trait Implementations
Blanket Implementations
impl<T> From<T> for T[src]
impl<T, U> TryFrom<U> for T where
U: Into<T>, [src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>[src]
impl<T, U> Into<U> for T where
U: From<T>, [src]
U: From<T>,
impl<T, U> TryInto<U> for T where
U: TryFrom<T>, [src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>[src]
impl<T> Borrow<T> for T where
T: ?Sized, [src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized, [src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T[src]
impl<T> Any for T where
T: 'static + ?Sized, [src]
T: 'static + ?Sized,
impl<T> Same<T> for T[src]
type Output = T
Should always be Self