[−][src]Struct lpc55s6x_pac::usbhsh::portmode::R
Value read from the register
Methods
impl R[src]
pub fn bits(&self) -> u32[src]
Value of the register as raw bits
pub fn id0(&self) -> ID0R[src]
Bit 0 - Port 0 ID pin value.
pub fn id0_en(&self) -> ID0_ENR[src]
Bit 8 - Port 0 ID pin pull-up enable.
pub fn dev_enable(&self) -> DEV_ENABLER[src]
Bit 16 - If this bit is set to one, one of the ports will behave as a USB device.
pub fn sw_ctrl_pdcom(&self) -> SW_CTRL_PDCOMR[src]
Bit 18 - This bit indicates if the PHY power-down input is controlled by software or by hardware.
pub fn sw_pdcom(&self) -> SW_PDCOMR[src]
Bit 19 - This bit is only used when SW_CTRL_PDCOM is set to 1b.
Auto Trait Implementations
Blanket Implementations
impl<T> From<T> for T[src]
impl<T, U> TryFrom<U> for T where
U: Into<T>, [src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>[src]
impl<T, U> Into<U> for T where
U: From<T>, [src]
U: From<T>,
impl<T, U> TryInto<U> for T where
U: TryFrom<T>, [src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>[src]
impl<T> Borrow<T> for T where
T: ?Sized, [src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized, [src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T[src]
impl<T> Any for T where
T: 'static + ?Sized, [src]
T: 'static + ?Sized,
impl<T> Same<T> for T[src]
type Output = T
Should always be Self