Struct lpc55s6x_pac::i2c0::mstctl::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn mstcontinue(&mut self) -> _MSTCONTINUEW

Bit 0 - Master Continue. This bit is write-only.

pub fn mststart(&mut self) -> _MSTSTARTW

Bit 1 - Master Start control. This bit is write-only.

pub fn mststop(&mut self) -> _MSTSTOPW

Bit 2 - Master Stop control. This bit is write-only.

pub fn mstdma(&mut self) -> _MSTDMAW

Bit 3 - Master DMA enable. Data operations of the I2C can be performed with DMA. Protocol type operations such as Start, address, Stop, and address match must always be done with software, typically via an interrupt. Address acknowledgement must also be done by software except when the I2C is configured to be HSCAPABLE (and address acknowledgement is handled entirely by hardware) or when Automatic Operation is enabled. When a DMA data transfer is complete, MSTDMA must be cleared prior to beginning the next operation, typically a Start or Stop.This bit is read/write.